![]() 24-Hour Technical Support: International:ġ0 Section I: Introduction Transition Networks CPSMM100-xxx firmware overview Firmware location The CPSMM100-xxx firmware is embedded in Transition Networks management modules. To do this, the administrator must know the serial number of the chassis and the slot number of the module. The administrator can retrieve and modify MIB variable values of a module, using the command-line interface (CLI). The manual also has the following: Index Appendix A: Command-Line Interface Commands (separate document) Appendix B: Command-Line Interface Messages (separate document) Focal Point new feature for version 2.1 Get/Set MIB values. Figure 1: 19-Slot Point System Chassis 2 24-Hour Technical Support: International:ĩ Section I: Introduction About this manual, continued How this manual is constructed This manual is divided into five sections, each with a beginning table of contents. Point system chassis The following is a list of Point System products: Point System chassis (single, dual, 8, 13, 18 or 19 slot) Point System slide-in-module media converters Point System management modules Focal Point 2.x management software (see website for current version) Point System power supply modules Point System accessories Visit for complete details on Point System chassis products. The management system is comprised of the following: Focal Point management software CPSMM100-xxx management module (MMU) and firmware Management SNMP management protocol Point System chassis containing various Transition Networks cards. 24-Hour Technical Support: International: iĦ Focal Point Management Software Intentionally Blank ii 24-Hour Technical Support: International:ħ Section I: Introduction In this section These are the topics: Topic See Page About this manual 2 CPSMM100-xxx firmware overview 4 Focal Point management software overview 5 Simple Network Management Protocol (SNMP) 6 24-Hour Technical Support: International:Ĩ Section I: Introduction Transition Networks About this manual Point System chassis management This manual explains how to set up (via a computer interface) Transition Networks (TN) Focal Point management software and the CPSMM100 firmware used to monitor and manage one or more Point System chassis populated with Transition Networks media converters. ![]() ![]() No part of this work may be reproduced, translated, or used in any form or by any means graphic, electronic, or mechanical without written permission from Transition Networks. Copyright restrictions 2006 Transition Networks. 1 Focal Point 2.1 Management Software & CPSMM100 Firmware Manual Manual Rev Bģ Focal Point Management Software Transition Networks Table of Contents Section I.1 Introduction.1 About this manual.2 CPSMM100-xxx firmware overview.4 Focal Point management software overview.5 Simple Network Management Protocol (SNMP) overview.6 Section II.9 Focal Point Management Software.9 Hardware setup.10 Focal Point software installation.11 Focal Point main window pull-down menus.13 Focal Point management software overview.19 Focal Point software web-based management.31 CPSMM100 firmware upgrades.36 Section III.39 Command-Line Interface (CLI).39 DB-9 serial port CLA access.40 RJ-45 Ethernet port CLA access.45 Network security.48 Redundant base-management module (MMU) configuration.57 Command-line interface reference information.59 Section IV.65 Troubleshooting & Cable Specifications.65 Troubleshooting problem and corrective action table.66 Cable specifications.69 Section V.71 Contact Us & Warranty.71 Contact us.72 Warranty.73 Index Hour Technical Support: International: iĤ Focal Point Management Software Intentionally Blank ii 24-Hour Technical Support: International:ĥ Focal Point Management Software Transition Networks Trademark and copyright information Trademark All trademarks and registered trademarks are the property of their respective owners. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |